The teeth should pierce up through the bottom of the strip and through the copper pads, making for a solid connection. Once it is in as far as possible, click the tab down. Make sure to lift up the clear plastic tab and slide the strip in as far as you can, making sure it is on top of these teeth. On the strip side there will be 2-4 sharp teeth sticking straight up where you need to slide the strip in. Strip-to-Wire: Strip connector clips onto the end of the strip but on opposite end you can connect wires for going back to the power source or adding a gap to your application. Strip-to-Strip: Easily connect a strip into either end for a gapless connection There are 2 and 4 pin versions of the following LED strip connectors: First off there are both connectors for single color and RGB tape light Single colors have a two pin connection whereas RGB strips have four. These connectors are super simple to use! Whether you need to make an end-to-and connection or need to add a gap between strips with wires, this connector has you covered. The Best LED Strip light connector around! The NEW EZ Clip connector is here! No more soldering or peeling back the silicone on the waterproof strips, these LED strip light connectors are hassle free and help you connect strips together with ease. Two Connection Types: Strip-to-Strip & Strip-to-WireĬompatible LED Strips: 10mm Wide, 2-pin or 4-pin No Soldering: hassle-free Hippo clip designĢ-Pin & 4-Pin: Available for single color as well as RGB Strip lights
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |